Normal Dialling - i-tec SOLAR Benutzerhandbuch

Switching handsfree ON
From OFF position, Handsfree is switched ON by pushing the MFB (5) for at least 4 sec. 1 times brief tone will be heard and blue LED will
commence blinking at intervals of 3sec - this indicates the Handsfree reached a standby mode.
Note: Prior to a first use, the Handsfree device must be paired with the mobile telephone (see chapter on "pairing")
Switching handsfree Off
From a standby position, Handsfree is switched OFF by pushing the MFB (5) for at least 4 sec. One longer tone shall be heard and the blue
LED Bluetooth (5) will change the colour from blue to red (will blinking 5 times). After several seconds, the device will shut down.
Note: To save power, Handsfree CarKit will automatically turn off if it is not connected to any device for more than 10 minutes.
Pairing
Note: Pairing could be implemented even when Handsfree CarKit is connected with the charger.
Actual Pairing Procedure
1. Locate the telephone to a close proximity of the Handsfree (ideally, up to 1m away).
2. Handsfree is at the beginning switched off.
3. Depress for about 6 sec. the MFB (5) pushbutton. After a long tone is heard, the LED diode Bluetooth (5) commences to blink
alternatively blue and red. Leave the Handsfree for about 2 minutes in pairing regime.
4. Afterwards, proceed in locating and connecting the Bluetooth device in accordance with the guide to your mobile telephone – MT (your
phone shall discover and announce the Handsfree device as SOLAR).
5. When asked about the password (PIN) of the device, select 0000.
6. Pairing was successful as long as the diode LED of the Bluetooth (5) ceases to blink alternative colours and shall flash only blue, with
3 sec intervals. Usually, your mobile telephone shall display the message about successful (resp. unsuccessful) pairing and the icon
Handsfree (Auto) or Headset (Earphones) will appear.
Note:
1. In case the pairing was unsuccessful within 2 minutes, please repeat the pairing process from the beginning. When the pairing was
successful, the Handsfree is ready for use.
2. Keep the MT and the Handsfree within a maximum of 10 m distance apart, otherwise the connection may be lost. In such a case,
(e.g. on the MT there is not the icon of Headset or Handsfree) the mutual connection must be re-established.
3. Loss of connection between the MT and Handsfree kit is indicated on the Handsfree by three brief sound signals, every minute for
over 10 minutes.
Answer a call
During incoming call, both Handsfree CarKit and the telephone will ring (depending on the given telephone).
1. For accepting the call, depress MFB (5)
2. For terminating the call, depress MFB (5)
cALL ReALizAtiON

Normal dialling

1. Dial the requested phone number / contact with aid of your telephone, as usual. Under regular conditions, the sound will be transferred
into Handsfree.
2. For terminating the call, depress MFB (5)