Tweeter Installation - Radical Audio Ra16.2Rf Bedienungsanleitung

Fig.: Crossover Wiring
AMP

TWEETER INSTALLATION

The tweeter units come with an aluminium main housing and a front rim that
features three mounting holes. After you have determined the best sounding
tweeter location, you can cut two holes with 50mm diameter, using a hole-saw
attachment for your power drill.
Before you mount the tweeters, you must solder a loudspeaker wire to the sol-
dering terminals located on the backside of the tweeter. Use a hot soldering
iron and avoid to heat up the terminals of this tweeter for too long, as the as
the plastic back cover may get soft or even melt away due to prolonged heat-
ing!
Insert the tweeter wire into the hole you have just cut, and fix the tweeters in
place using the self tapping screws provided by the mounting hardware set.
7