Proline Promag 50 Einbauanleitung

Installation Instructions
Promag 50, 51, 53, 55, Promass 80, 83, 84, Prosonic Flow 90, 93, t-mass 65
Mounting set for wall-mount housing
EA097/06/a2/10.09
71105611
These instructions apply to the following post mounting kits:
Order Number Original Accesories kit
Mounting set for wall-mount housing G03
4 × mounting part G03 universal blue
4 × screw M5 × 16
DK5WM-A
4 × setscrew M6 × 115
4 × nut M6 × 0.8
4 × washer spring M6
Mounting set for wall-mount housing G03
4 × mounting part G03 universal blue
4 × screw M5 × 16
DK8WM-A
4 × setscrew M6 × 115
4 × nut M6 × 0.8
4 × washer spring M6
1 Safety Instructions
• Comply with national regulations governing mounting, electrical installation,
commissioning, maintenance and repair procedures. (Available sources,
e.g. series of standards IEC 60364 and IEC 60079 -14/-17/-19).
• Requirements with regard to specialized technical staff for the mounting, electrical
installation, commissioning, maintenance and repair of the measuring devices:
– trained in instrument safety
– familiar with the individual protection concepts of the devices
– for Ex-certified measuring devices: also trained in explosion protection
• If you have any questions, contact your E+H service organization.
• Modifications to the measuring device are not permitted.
• Follow all measuring device documentation.
• In the case of Ex-certified measuring devices: Comply with the installation
instructions and operating conditions in the supplementary Ex-documentation.
Tool List
PH2
10 mm
Order Number Original Accesories kit
Mounting set for wall-mount housing G03
4 × mounting part G03 universal blue
4 × screw M5 × 16
DK9WM-A
4 × setscrew M6 × 115
4 × nut M6 × 0.8
4 × washer spring M6
Mounting set for wall-mount housing G03
4 × mounting part G03 universal blue
DK6WM-A 4 × screw M5 × 16
4 × setscrew M6 × 115
4 × nut M6 × 0.8
4 × washer spring M6
• Hot surfaces! Risk of injury!
Before commencing work, allow the system and measuring device to cool
down to a touchable temperature.
• Danger: Risk of electric shock! Only open the measuring device in a de-
energized state.
• Observe the instructions for transporting and returning the device outlined in
the Operating Instructions.
"
Note!
Make sure that the ambient temperature does not exceed the permitted range.
Always install the wall-mount housing in such a way that the cable entries point
downwards.