Herunterladen Diese Seite drucken

Remington MB4560 Handbuch Seite 7

Vorschau ausblenden Andere Handbücher für MB4560:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 9
ENGLISH
• Cleaning should only be done with a soft brush.
, CLEANING CAUTIONS
• Do not rinse under water.
• Do not use harsh or corrosive cleaners on the units or their blades.
• Only use a light-grade oil or sewing machine oil on the blades.
• Do not use harsh or corrosive cleaners on the units or their cutters.
• Do not submerge in water as damage will occur.
, RESET INSTRUCTIONS
• You will never have to force a system reset under normal conditions. If the
clipper experiences abnormal behaviour, such as low or high touch
sensitivity or subjected to electrostatic discharge disturbance, or subjected
to electrical fast transient/burst from the LV network, the system can be
reset.
• Hold the mode button for 8 seconds with the product switched on and the 3
position slide switch set to the middkle position, the system will enter reset
mode.
• System will show 88.8mm, full battery, full lock and full boost level.
• Ensure no objects, hands or fingers are near the touch buttons.
• Push the mode button once.
• The comb will travel down to its lowest setting and the display will show the
current battery level, lock status and 1st boost level.
• Let the product sit until the screen dims.
• Product is now ready, turn it on and confirm proper function.
, STORAGE
• Always store this appliance and cord in a moisture-free area. Do not store it
in temperatures exceeding 140°F (60°C).
• Do not wrap the cord of the charging adaptor around the appliance.
BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing
the battery.
• Turn the trimmer on and discharge all remaining power.
• Remove the comb attachment.
• Detach the blade head.
• Remove the head clip using a screw driver.
• Using a screwdriver carefully pry apart the top and bottom housing
• Unscrew the (2) screw on the circuit board.
7

Werbung

loading