Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Test Modes
1. 10BaseT Cable test
Step 1
Plug one end of the tested cable into the transmitting RJ45 jack on the master unit marked with an arrow
and the other end of the cable into the remaining receiving RJ45 jack
Step 2
Slide power switch on. The upper row of LEDs will start to scan in sequence if the Auto/Manual button is
set on "Auto" mode. The LED for pin 1 will light up if the button is in "Manual" mode.
Step 3
Switch back and forth from Auto or Manual scanning mode by pressing the Auto/Manual button on the side
of the master testing unit.
Step 4
Once both ends of the cable are plugged in properly, the second row of LEDs will illuminate according to
the corresponding LEDs in the top row.
Step 5
Read the results of the LED display for the pin configuration status of the tested cable. If you fail to read
the results the first time in Auto mode, you may wait for the second LED scan, or simply switch to Manual
mode for pin by pin testing. In Manual mode, pressing the square "Test" button will advance testing to the
next pin.
2. 10Base-2 cable test
Step 1
Plug the two attached BNC adapter cables on both RJ45 jacks. Then connect the tested cable to each end
of the BNC adapter cables.
Step 2
Please follow directions for the UTP/STP Cable Test and use the operations manual for the correct LED pin
out display
Werbung
