Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The InLine® Network Cable Tester is an innovative, practical tester that can easily read the correct pin
configuration of 10BASE-T, 10BASE-2, RJ45/RJ11 modular, 258A, TIA-568A/568B and Token Ring cables by
comparing one transmitting end to the corresponding receiving end. The included remote terminator allows
the user to test installed cable either at a wall jack or a patch panel. Verifying continuity and testing for
faults such as open, shorted and crossed pairs has never been easier and more affordable.
Features
Displays the actual pin configuration of 10BASE-T and 10BASE-2 Ethernet, RJ45/RJ11 modular,
258A, TIA-568A/568B and Token Ring cables
Provides easy to read continuity and fault status display
Checks for continuity, open wire, shorted pair and crossed pair faults
Allows for remote testing of installed cables from wall jack or patch panel
Tests shield wire integrity
Auto or manual scanning
Produktbeschreibung
1. RJ45 JACK
2. RJ45 JACK
3. LED Display for Sourcing End Jack1)
4. LED Display for Receiving Rnd (Jack2)
5. Power Switch
6. LED Scanning Mode switch (auto/manual)
7. TEST Switch for manual Scan
8. RJ45 JACK
9. LED Display for Receiving End
10. Ground- LED for Receiving END
11. Battery Compartment (9V) Back side
Manual
Item No. 79998
InLine® Tester for BNC, RJ11, RJ45
Werbung
