Installation - DETEWE M100-ADSL Bedienungsanleitung

M100-ADSL Interface
DSL Modem
The M100-ADSL interface DSL
modem is an integrated DSL modem.
It enables you to operate the
OpenCom 100 (OpenCom 130/150) on
a DSL access without having to acquire
an external DSL modem. The M100-
ADSL interface DSL modem supports
the U-R2 interface in accordance with
1 TR 112.
This user guide assumes that you al-
ready have a DSL access and that the
splitter has been installed.

Installation

Installation of the interface card
should only be performed by spe-
cially trained personnel.
For information on installing the
OpenCom 100 modules and interfaces,
please refer to the chapter entitled
"Mounting and Commissioning" in the
OpenCom 100 user guide.
Proceed as follows:
DANGER! This device contains
hazardous voltages.
1. Turn off the OpenCom 100.
Open the housing cover.
Installation Guide
Scope of Delivery
One M100-ADSL interface DSL
■
modem interface card
■ One RJ45 cable for connecting the
interface card to the splitter
One set of cable ties for securing
■
the connection cable
One installation guide.
■
2. Remove the interface card from its
transport packaging. Check that it
is the correct type of card. (There is
a sticker with the type name on the
connector.)
CAUTION! Static charges can
damage electronic components.
Pay attention to the regulations re-
garding the installation of electro-
statically sensitive components.
M100-ADSL Interface DSL Modem
7