DETEWE M100-ADSL Bedienungsanleitung Seite 10

Configuration
When you have restarted the
OpenCom 100, you use the
Configurator in the Web console to
configure the DSL modem. Please also
refer to the information in the
OpenCom 100 online help.
Proceed as follows:
1. Log in to the Configurator as a
user with administrator rights.
Note: In order to configure the DSL
modem via the OpenCom 100 Web con-
sole, you require Version 5.1 or higher of
the firmware. If necessary, first use the
SYS Configuration: Firmware menu to
load the new firmware. Then use the
SYS Configuration: Components
menu to load the current version of the
online help.
2. Open the PBX Configuration:
Ports: Slots menu. The card type
DSL modem appears in the in-
serted column of the table for the
selected Slot.
3. In order to begin operating the DSL
modem, you must first configure it.
To do this, you click on the entry
Slot in the table.
The PBX Configuration - Ports -
Slot - Change dialogue opens.
M100-ADSL Interface DSL Modem
10
4. You then select the card type DSL
modem from the Configured list,
and confirm your selection by
clicking on Apply.
5. In order to establish connections to
the Internet via the DSL modem
you must configure a suitable ISP
connection. To do this, open the
NET Configuration: Connections:
ISP menu. Click on the New button
on the ISP - Provider status page.
The ISP - Provider - New dialogue
opens.
6. Select one of the following types of
connection: T-Online T-DSL
(PPPoE), T-Business T-DSL
(PPPoE) or DSL (PPPoE). Complete
the data in the input fields that
now open (for details, please see
the online help). To confirm your
input, click on Apply.
Note: If another xDSL modem is
already being operated via PPPoE in
the same LAN, conflicts can arise when
connections to the Internet are estab-
lished (there is a risk of confusion).
Remove the other DSL modem from the
LAN, and deactivate the corresponding
modem drivers on all PCs that used to
access this modem.
Installation Guide