Problem Solving - RUSTA 90101061 Gebrauchsanweisung

ENG
PROBLEM-SOLVING
The microwave oven disrupts TV
reception.
The light in the microwave oven
is weak.
Steam forms on the door and
hot air comes out of the vents.
The microwave oven starts ac-
cidentally without food in it.
Problem
The microwave oven does not
start.
The glass turntable makes noise
when the microwave oven is
operating.
CLEANING
• Remove the plug from the electrical outlet before cleaning the microwave oven.
• Clean the inside with a damp cloth. For tough dirt, fill a plastic bowl with 3 cups of
waters and add half a lemon. Heat on full power for 10 minutes. Dry the inside with a
dry cloth.
• Wash cooking utensils in water and soap and rinse with clean water.
• Clean the door latch and sealing strip carefully with a damp cloth.
• Clean the glass turntable, the rotating ring and the axle with a damp cloth and then
dry with a dry cloth.
• Do not clean the microwave with steam.
• Do not use caustic or abrasive cleaning agents which can damage the microwave's
casing and scratch the glass in the door.
• If the microwave is not kept clean and in good condition, it will wear out faster, its
useful life is shortened and the risk of personal injury or the microwave no longer
working increases.
8
Radio and TV can be disrupted when the microwave oven is
operating. Similar disruption can occur when using small hous-
ehold devices, such as blenders, vacuum cleaners and electric
fans. This is entirely normal.
When cooking at low power, the light may be weaker.
This is entirely normal.
During cooking, steam forms and most of the steam goes out
through the vents. However, some steam collects on the door.
This is entirely normal.
It is very dangerous, since the radio waves must be
absorbed by something.
Possible cause
The plug is not sitting properly
in the electrical outlet.
The fuse blows or the circuit
breaker activates.
Problem with the electrical
outlet.
The door latch is not closed.
There is dirt on the bottom of
the microwave oven and on
the axle.
Solution
Remove the plug, wait 10
seconds and plug it in again.
Replace the fuse or contact an
electrician to reset the circuit
breaker.
Test whether there is power in
the electrical outlet by connec-
ting other electrical devices.
Close the door latch properly.
Clean these parts.