Connections; Audio Connections; Cleaning And Maintenance; Technical Specifications - Omnitronic TS-8 Bedienungsanleitung

6. CONNECTIONS

1. To prevent switching noise, switch off the units to be connected to the outputs, or mute their inputs to
reduce them.
2. In order to obtain highest sound quality, only use high-quality cables for connecting the devices. Make
sure that the cables are properly fixed.
3. Connect the outputs of the of the audio sources to the input jacks INPUT.
4. Connect the inputs of the audio units to be directly connected to the output jacks OUTPUT.
5. If neccessary (in case of hum noise problems), use the terminal screw for a ground connection on the
rear panel.

6.1 Audio connections

Unbalanced use of
mono 1/4" jack plugs
Tip =
Signal (+)
Sleeve =
Ground / Shield
Tip
Sleeve
Strain relief clamp

7. CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.

8.TECHNICAL SPECIFICATIONS

Frequency range:
THD:
Channel separation:
CMRR:
Phase error:
Insertation loss:
Audio connectors:
Dimensions:
Weight:
Please note: Every information is subject to change without prior notice. 18.09.2007 ©
Balanced use with XLR connectors
2 1
1 = Ground / Shield
2 = Hot (+)
3 = Cold (-)
3
Input
For unbalanced use pin 1 and pin 3 have to be bridged
10 Hz - 50 kHz, ± 5dB @ +4 dBu
0.01% typical @ 0.1 kHz, + 18 dBu, <1% @ 100 Hz, + 24 dBu
90 dB typical
60 dB typical
<5°, 20 Hz - 20 kHz
0.4 dB @ 100 kOhm
5.5 dB @ 600 Ohm
XLR, balanced
6.3 mm (1/4") jack, balanced
RCA stereo
483 x 115 x 45 mm
2 kg
1 2
3
Output
12/12 00030234.DOC, Version 1.0