Front Panel; Rear Panel; Installation - Omnitronic TS-8 Bedienungsanleitung

4.2 Front panel

1. MOUNTING BRACKETS
For more flexibility in cabling your system, the TS-8's mounting brackets are reversible so you can have
either the 6.3 mm jacks and the RCA jacks on the front or the XLR jacks on the front.
2. 6.3 mm MONO INPUT
Input of channels CH 1 - CH 8.
3. 6.3 mm MONO OUTPUT
Output of channels CH 1 - CH 8.
4. RCA MONO INPUT
Input of channels CH 1 - CH 8.
5. RCA MONO OUTPUT
Output of channels CH 1 - CH 8.

4.3 Rear panel

1. MOUNTING BRACKETS
For more flexibility in cabling your system, the TS-8's mounting brackets are reversible so you can have
either the 6.3 mm jacks and the RCA jacks on the front or the XLR jacks on the front.
6. XLR MONO INPUT
Input (XLR, balanced) of channels CH 1 - CH 8.
7. XLR MONO OUTPUT
Output (XLR, balanced) of channels CH 1 - CH 8.

5. INSTALLATION

5.1 Rack-installation
This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-Rack where you can
open the front panel and the rear panel. The rack should be provided with a cooling fan. When mounting the
device into the rack, please make sure that there is enough space around the device so that the heated air
can be passed on. Steady overheating will damage your device. You can fix the device with four screws M6
in the rack. If several devices are to be installed, make sure that you leave 1 unit space between the devices.
11/12 00030234.DOC, Version 1.0