Unpacking And Removing Transit Bolts - LG F16F9BDH0NH Bedienungsanleitung

Unpacking and Removing Transit
Bolts
1
Lift the appliance off the foam base.
• After removing the carton and shipping material,
lift the appliance off the foam base. Make sure
the tub support comes off with the base and is
not stuck to the bottom of the appliance.
• If you must lay the appliance down to remove
the carton base, always protect the side of the
appliance and lay it carefully on its side. Do not
lay the appliance on its front or back.
Tub Support Carton base
(Optional)
2
Remove the bolt assemblies.
• Starting with the bottom two transit bolts, use the
spanner (included) to fully loosen all transit bolts
by turning them counterclockwise. Remove the
bolt assemblies by wiggling them slightly while
pulling them out.
Transit
bolt
10
3
Install the hole caps.
• Locate the hole caps included in the accessory
pack and install them in the shipping bolt holes.
Cap
NOTE
• Save the bolt assemblies for future use. To prevent
damage to internal components, Do not transport the
washing machine without reinstalling the transit bolts.
• Failure to remove transit bolts and retainers may
cause severe vibration and noise, which can lead to
permanent damage to the washing machine. The cord
is secured to the back of the washing machine with
a shipping bolt to help prevent operation with transit
bolts in place.