Cleaning And Maintenance - reer SkinTemp 98020 Gebrauchsanleitung

The device is not water-proof and thus must not be immersed in water
or directly in liquid.
The „object/ambient temperature" mode only displays the radiation
temperature of the surface/room temperature and does not give any indica-
tion regarding the body temperature. This measuring mode thus cannot be
used for measuring a fever temperature.
Remove any water, dust or dirt from the measurement object to
improve measurement accuracy.
Other
Setting the time
The time must be set before using the thermometer for the first time and after
every battery change; the time is then displayed in idle mode, alternating with
the room temperature.
1
press!
CR2032
3
press!
5
press!
20
2
press!
CR2032
4
press!
CR2032
6
6
press!
CR2032
Note: Battery consumption in idle mode is minimal. If you do not want anything
displayed in idle mode, you can skip setting the time.
Automatic idle mode
The device automatically switches to idle mode after approximately
30 seconds of inactivity. The time is then displayed, alternating with the
ambient temperature.
Measured value memory
The thermometer automatically saves the temperature values of the last
19 measurements. If the 19 storage spaces are exceeded, the oldest available
value is overwritten.
press!
CR2032
2–3
sec

Cleaning and maintenance

The sensor is the most sensitive part of the infra-red thermometer. Please be
careful not to scratch the surface of the measuring sensor. If the sensor is dirty,
carefully clean it with a cotton swab soaked with alcohol or a mild detergent
(e.g. a highly diluted dish washing detergent). Do not use any aggressive cleaning
agents. Clean the case and display with a soft dry cloth or an alcohol pad.
The device is not water-proof and thus must not be immersed in water or expo-
sed to direct humidity. This product does not require any special maintenance.
Repairs must be carried out by skilled personnel only.
press!
21