Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8.
Important Safety Instructions
During usage of the projector following safety instruction must be followed:
8.1 Please read all the instructions of this manual before using the projector. Do not
allow children to operate this projector without adult guidance. Do not touch the
hot parts of this projector in order to avoid skin burn.
8.2 Do not operate this projector when the power cord was damaged. Do not open
or operate this projector after damage due to drop down. Please contact your
local dealer for examination and repair. If an extension cord is needed, please
use an appropriate one. If the wires are too thin, it could easily be overheated
and damaged.
8.3 Make sure that the power cord has no mechanical contact to hot parts, neither
to hot parts from the projector nor to external hot parts, e.g. oven or heater.
Damaged power cords must be replaced by authorized service providers.
8.4 Unplug this projector when it is not in use. Just gently pull the plug, not the cord
when disconnecting this unit from the mains socket. Before storage the
projector must be cooled down completely.
8.5 Place this projector on a stable and horizontal surface. To avoid electric shocks
and damages of the projector, please do not operate this projector when it is
wet or on a wet surface.
8.6 To avoid electric shock never try to disassemble this unit for repair by yourself.
Always contact the local authorized service provider for repair. Before replacing
the lamps please unplug the projector from mains and wait until it is cooled
down completely (wait 30 minutes after switch-off). Never touch the projection
lens or the projection mirror while the lamp is switched on. Never look into the
light beam or light source directly. It can injure your eyes.
8.7 Do not block the ventilation area in order to allow proper cooling. To avoid
damages of the projection mirror and the projection lens always tilt up the
mirror first before switching on the lamp.
8.8 If this projector needs maintenance or switches off due to overheating or a
burned fuse, please contact your local authorized service provider. To avoid any
damages of the unit or poor performance please use the specified and
manufacturer approved lamps only.
8.9 Use the projector only for projection of transparencies or other
documents/objects approved by manufacturer.
7
Werbung
