Electrolux IHL9028CN Gebrauchsanleitung Seite 6

www.electrolux.com
6
4. CONTROLS
L
Button Function
L
T1
T2
T3
T4
S1
5. LIGHTING
• For replacement contact tech-
nical support ("To purchase
contact technical support").
T1
Turns the lights on/off at maximum strength.
Turns the motor on/off at speed one.
Turns the Motor on at speed two.
Press and hold the button for approximately 3 seconds, with
all the loads turned off (Motor and Lights), to turn the Activated
Charcoal Filter alarm on. The relevant LED flashes twice to confirm.
To turn the alarm off, press the button again and hold for at least
3 seconds. The relevant LED flashes once.
Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all
the loads turned off (Motor and Lights), to perform a reset. The
LED S1 flashes three times.
Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this time,
the system returns automatically to the speed that was set before.
If it is activated with the motor turned off, the hood will switch to
OFF at the end of the time.
Press and hold for 3 seconds to enable the remote control,
indicated by the LED flashing twice.
Press and hold for 3 seconds to disable the remote control,
indicated by the LED flashing just once.
Signals the Metal Grease Filter saturation alarm, indicating that
it is necessary to wash the filters. The alarm is triggered after
the Hood has been in operation for 100 working hours. (Reset
see the parag. Maintenance).
When this is activated, it signals the Activated Charcoal Filter
saturation alarm, indicating that the filter must be changed;
the Metal Grease Filters must also be washed. The Activated
Charcoal Filter saturation alarm comes into operation after the
Hood has been working for 200 hours. (Activation and Reset see
the parag. Maintenance).
T2 T3
S1
T4
Led
-
Fixed.
Fixed.
Fixed.
Fixed.
Fixed.
Flashing.