QRS -101 Bedienungsanleitung Seite 60

Activation and deactivation of both timers start on a switched-off device. To program the timer 1 please press
1
the -key keeping it pressed. Now turn the device on via
To activate the timer apply the
change, accordingly. This command must be confi rmed via the
If the timer is deactivated, the device will now start with the standard operating mode. If the timer is activated
you may now start with its programming.
As its fi rst programming step you will set the time at which the therapy shall be started, automatically. The
display will show the following menu (exemplary time):
The blinking cursor is positioned on the time's fi rst digit „2", as shown above. You may now change the time
GB
by increasing the digit positioned below the cursor by pressing the
A/B
OK
The -key confi rms the current value and goes to the next position.
After confi rming the last time digit you automatically reach the menu to set the therapy parameters. Alterna-
tely you can now see the settings programmed for this timer regarding therapy program, therapy intensity,
therapy duration and applicator. To change one or several of these settings you may press the corresponding
control key in any given order.
Should 2 applicators be connected to the control unit you may also change the respective applicator via
A/B
OK
-key. After the fi rst click on this key the programmed applicator will be displayed for 1.5 seconds.
The respective applicator will be changed by pressing the
visible – i.e. no later than 1.5 seconds after the fi rst click.
Programming the timer is concluded by pressing the
set values will be saved for this timer. By pressing the Start-/Stop-key the device will be set to the standard
operating mode. The on/off-key will turn the device off.
!
NOTE
If a QRS
later, the device will switch on, independently, display the text „AUTOMODE" and switch off
again.
22
TIMER 1: [OFF] . . .
2
-key, to deactivate the timer apply the
TIME T1: 22:30
®
-101 control unit with activated timer is taken out of the power supply and reconnected
On/Off
-key. The display will then show
A/B
OK
-key.
2
-key, or to lessen it via the
A/B
OK
-key a second time while the display is still
Stop
On/Off
Start
or -key. In both cases all previously
1
-key. The display will
1
-key.