Data Transmission Protocols - eLine ARION Bedienungsanleitung

thanks to a sophisticated calculation based on the
speed. Since this is not a direct measurement, but the
result of a calculation, in particular situations the
cadence value may not be accurate.
IMPORTANT
Pay attention to the position of
hands when closing the roller,
to avoid squashing them between
the two side members

DATA TRANSMISSION PROTOCOLS

As previously mentioned, the Arion Digital Smart B+
employs wireless transmission to connect the
hometrainer to an app/software/device.
The hometrainer uses two types of wireless protocol,
ANT+ and Bluetooth Smart:
TM
- ANT+ FE-C protocol sends hometrainer data and
TM
NAME AND LIST OF COMPONENTS
A
N°3 Side members
B
N°1 Longitudinal member with resistance
C
N°4 Rectangular covers
D
N°2 Round covers
E
N°1 Drive belt
ASSEMBLY
Your Arion Digital Smart B+ roller should arrive fully
assembled, checked and ready for use.
DISTANCE ADJUSTMENT
OF ARION DIGITAL SMART B+
Before starting to use your
necessary to adjust the centre distance of the rollers to
Arion Digital Smart B+ it is
adjusts resistance from the app/device.
ANT+ Power and Bluetooth Smart power protocols
TM
send the rider's power value estimate.
ANT+ Speed&Cadence and Bluetooth Smart Power
TM
protocols send rider's speed and cadence values.
- Bluetooth Smart Elite Trainers protocol adjusts the
hometrainer resistance from the app/software/device.
Please contact the app/software/device manufacturer
to verify compatibility with one or more of these
protocols.
A few additional remarks on the use of these
protocols:
- When the hometrainer is connected to the device by
a Bluetooth Smart protocol, it cannot be connected to
additional devices. This is a restriction of the Bluetooth
Smart protocol itself.
- When a hometrainer connects with an ANT+
protocol, it stops sending data with the Bluetooth
Smart protocol (and vice-versa).
F
N°1 Front roller
G
N°1 Middle roller
H
N°1 Rear roller
I
N°1 Power adapter
N°1 Allen key
make them compatible with your bicycle's wheelbase.
This adjustment must be carried out as follows:
1) Measure the distance between the centres of the
wheels of the bicycle to be used on the
Smart B+ (Fig. 2). We will call this dimension "X".
2) The distance from the intermediate point between
the two rear rollers to the middle of the
Smart B+ front roller, which we will call "Y" (Fig. 3),
must match or be as near as possible to dimension "X"
. The axle of the Arion Digital Smart B+
EN
TM
Arion Digital
Arion Digital
front roller must
9