Whirlpool WTV4224 W Bedienungsanleitung Seite 6

ABNORMAL APPLIANCE OPERATION
When the product is plugged in to the mains, during first
10 minutes of its performance, possible temperature
sensor failure will be displayed according to following
table:
Refrigerator
Evaporator
sensor failure
Legend LED OFF
The appliance will work preserving the food stored, but it
is necessary to contact after-sales service and provide
alarm code.
Note: in case of power failure, appliance goes back to
normal operation and previously chosen setpoint is
restored.
CLEANING
Regularly clean the appliance using a cloth and a solution
of warm water, with some soft detergent suitable for
cleaning the inside of the refrigerator compartment.
Do not use abrasive detergents or tools.
To ensure continuous and correct flow of defrost water,
regularly clean the inside of the draining hole on the back
of the refrigerator near the fruit and vegetable drawer,
using the tool provided .
Before carrying out any cleaning or maintenance
operation, unplug the appliance or disconnect it from the
power supply.
DEFROSTING THE REFRIGERATOR
COMPARTMENT
Refrigerator compartment defrosting is completely
automatic.
Droplets of water on the rear wall inside the refrigerator
compartment indicate that the automatic defrost phase is
in progress. The defrost water is automatically run into a
drain hole and collected in a container, where it
evaporates.
PRODUCT SHEET
Refrigerator Refrigerator &
sensor failure Evaporator
sensor failure
LED Flashing
D
DEFROSTING THE FREEZER
COMPARTMENT
The freezer should be defrosted once or twice a year or
when excessive frost is present (3 mm thickness). The
thin formation of frost is normal.
Before defrosting the freezer compartment unplug the
appliance or disconnect it from the power supply.
Defrosting the freezer compartment should be done
manually by open the door till the all of ice will be melted.
During defrosting process please wipe the compartment
with a rag to avoid water penetration into the product.
Before restarting the product make sure that
compartment is fully dry.
REPLACING THE LIGHT
Always disconnect the refrigerator from the power supply
before replacing any light bulb.
If the inside light is not working, it is necessary to:
1. Remove the light cover: move it upwards as shown in
figure.
2. Check the bulb. If necessary unscrew the broken bulb
and replace it with a traditional bulb MAX 15 Watt or a
LED bulb of the same type available only at our After-
sales Service Centers or authorized dealers.
3. Put on the light cover.
Do not leave the bulb uncovered.
F
GB I PL
GB