Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TEMPERATURE SELECTION
Press the pushbutton on the control panel to adjust the
temperature.
Temperature selection pushbutton is used to set desired
temperature level, from warmest
Pressing pushbutton setpoint will
change cyclically. Temperature set-point is done for both
compartments at one time – fridge and freezer. At first plug-in of
appliance factory set-point is chosen – medium position. Following
table shows set-points level:
High temperature
Med-high temp.
Medium temp.
Med-low temp.
Low temp.
FUNCTIONS
Fast Cool
Using Fast Cool function it is possible to increase the cooling in the
refrigerator compartment. The use of this function is recommended
when placing a very high quantity of food in the refrigerator
compartment.
Press "Fast Cool "button to activate/deactivate Fast Cool function.
When activated, the Fast Cool icon lights-up
The function is automatically deactivated after 6 hours.
Note:
- Fast Cool function should be also switched ON before placing fresh
food to be frozen in the freezer compartment, in order to
maximize the freezing capacity.
"6th Sense Fresh Control" /
"Green Intelligence ProFresh"
This function allows optimum storage conditions (regarding
temperature and humidity) to be quickly reached inside the
appliance. The fan must also be switched on for it to work properly.
The "6th Sense Fresh Control"/ "Green Intelligence ProFresh"
is activated by default. To minimize the Energy consumption is
suggested to disable the "6th Sense Fresh Control"/ "Green
Intelligence ProFresh" function and fan. To manually deactivate the
function, press the "Temperature & Fast Cool buttons" for 3sec: the
6th Sense Fresh Control icon turns off as confirmation that the
feature has been deactivated. The function can be reactivated by
repeating the same procedure.
FREEZING FRESH FOOD
Place the fresh food to be frozen on the upper basket in the freezer
compartment. Avoid direct contact with already frozen food. To
freeze the quantity of food shown on the rating plate, switch on Fast
Cool function before placing fresh food to be frozen. After 24 hours
the food will be frozen.
CLEANING
Regularly clean the appliance using a cloth and a solution of warm
water, with some soft detergent suitable for cleaning the inside of
the refrigerator compartment. Do not use abrasive detergents or
tools. To ensure continuous and correct flow of defrost water,
regularly clean the inside of the draining hole on the back of the
refrigerator near the fruit and vegetable
drawer, using the tool provided. Before
carrying out any cleaning or
maintenance operation, unplug the
appliance or disconnect it from the
power supply.
DEFROSTING THE REFRIGERATOR COMPARTMENT
Refrigerator compartment defrosting is completely automatic.
Droplets of water on the rear wall inside the refrigerator
PRODUCT SHEET
through lower
to coldest
Legend
Led ON
Led OFF
D
GB
compartment indicate that the automatic defrost phase is in
progress. The defrost water is automatically run into a drain hole
and collected in a container, where it evaporates.
DEFROSTING THE FREEZER COMPARTMENT
.
The freezer should be defrosted once or twice a year or when
excessive frost is present (3 mm thickness).
The formation of frost is normal.
The amount and rate at which frost accumulates depends on room
conditions and how often the door is open.
To defrost the unit, switch off the whole appliance and remove all
food products.
Leave the freezer door open to allow the frost to melt.
Pull out the defrost water drain and place a
container under the drain (see figure).
When the operation is completed, put back the
defrost water drain.
Clean the inside of the freezer. Rinse and dry
thoroughly. Switch the freezer compartment, or
the whole appliance, back on and store the food
inside.
REPLACING THE LIGHT (depending on the model)
BULB's LIGHTING
Always disconnect the refrigerator from the power supply before
replacing any light bulb.
If the inside light is not working, it is necessary to:
1. Remove the light cover: put the fingers into the side ventilation
holes (1), stretch the cover gently and move
it upwards.
2. Check the bulb. If necessary unscrew the
broken bulb and replace it with a traditional
bulb (with the same characteristics of the previous one) or a LED
bulb of the same type available only at our After-sales Service
Centers or authorized dealers.
3. Put on the light cover.
Do not leave the bulb uncovered.
LED's LIGHTING
If the inside LED light is not working, it must
be replace by service.
Important:
The refrigerator compartment light switches on when the
refrigerator door is opened. After 10 minutes of door opening the
light switches off.
MALFUNCTION AND ALARM INDICATIONS:
Operation Alarms
In the event of operation alarms, they will be displayed in the Fridge
Temperature LEDs, (e.g. Failure1, Failure 2, etc...) call After-sales
Service and specify the alarm code.
The acoustic alarm sounds, the
central LEDs in the Fridge Temperature LEDs blinks according to
failure code described below:
Failure code
RC Set points blink on/off at 500msec.
Error 2
Blinks ON 2 times then remain off for
5 seconds. Pattern repeats.
RC Set points blink on/off at 500msec.
Error 3
Blinks ON 3 times then remain off for
5 seconds. Pattern repeats.
RC Set points blink on/off at 500msec.
Error 6
Blinks ON 6 times then remain off for
5 seconds. Pattern repeats.
Legend
Led OFF
Led flashing
F
I
PL
GB
Alarm icon lights up and the 3
Visualization
X2
X3
X6
Werbung
