VEVOR B11 Originalanleitung Seite 8

Step 6:Pull out the gate to fit your doorway width, and screw it(L-O) to
tight the gate.
If the adjustment distance is just right between the two pipe fittings, adjust
it back a little so that L,M,N and O close.
Step 7: Lift out the entire door railing, adjust the length of the upper and
lower screws, then fasten the door railing until the handle grips the lock
head and is level with the lock head. Finally, use a wrench to tighten the nut
and install the pivot cover.
- 7 -