Troubleshooting - IKEA UPPLEVA Handbuch

1. Press Power/mode briefly to set the glasses to 3D
mode.
2. In 3D mode, press Power/mode for 1s to set the
glasses to left eye mode.
3. In left eye or right eye mode, press Power/
mode for 1s to switch between left eye and right
eye modes. Press Power/mode for 6s to set the
glasses to standby.

Troubleshooting

There is no 3D effect after the 3D glasses are
powered on:
• Make sure the 3D glasses are less than 6 metres
away from the TV.
• Make sure the TV is in 3D mode.
• Check if the pairing is completed or not by
pressing and holding Power/mode for 6 seconds.
• Replace the battery if it is discharged.
The 3D image is flashing or flickering:
• The battery is nearly discharged. Replace it with
a new one.
• There is light interference around, such as
strong magnetic fluorescent light (50/60Hz). If
interference happens, turn off the light.
9