Palmer PFFX Effects Bedienungsanleitung Seite 9

OPERATING INSTRUCTIONS
1
INPUT
Use a quality instrument cable with 1/4" jacks to connect your
guitar to this socket.
2
OUTPUT
Use a quality instrument cable with 1/4" jacks to connect this
output to your amplifier's input.
3 4
SEND AND RETURN 1 AND 2
AND
These are the outputs (SEND) and inputs (RETURN) for effect loops 1
and 2. Using a quality 1/4" jack instrument cable of ample length,
connect SEND 1 to the input of the pedal you want to place first in
loop 1. To add more effects to the loop connect the pedal's output
to the next unit's input etc. using quality 1/4" patch cords. To
complete loop 1 connect the final pedal's output to RETURN 1. Do
likewise for loop 2.
NOTE: Loop 1 and 2 are wired in series, i.e. if both are activated
loop 1 is before loop 2 in the signal path. Bear this in mind when
arranging your effects. While pedal order is highly subjective and
there are no common rules wahs, compressors, distortion, fuzz and
overdrive pedals are generally supposed to be placed right after
the guitar so these should go into loop 1 preferably. Feel free to
experiment, though, for that tone of your own!
5
9V DC INPUT
Connect an optional center negative 9V DC power adapter to this
socket. For details please refer to "POWER REQUIREMENTS".
NOTE: Power is required to operate the loop on / off LED indicators
only. The PFFX is fully functional without battery or adapter pow-
er, however, the LEDs will not light up when loops are selected.
9 9 9