Linea 2000 DOMO DO1191SC Gebrauchsanleitung Seite 36

3
I
Do not shake the filled clean water tank when placing it on the device to avoid spillage.
USE
I
Do not add detergent to the clean water tank.
I
Never use the device on fabrics or surfaces that are not water-resistant. If you are unsure
whether the object is water-resistant, perform a cleaning test on a small area to avoid causing
any damage.
I
Always place the object to be cleaned on a water-resistant surface.
I
Do not use the device to clean any seats with seat heating or electrical wiring.
1. Insert the mains plug into the power socket.
2. Turn on the device by pressing the power button.
3. Press and hold the spray button on the handle to moisten the surface to be cleaned. The longer
you press the button, the wetter the surface becomes.
4. After moistening the surface, slowly move the suction nozzle over the moistened surface. While
doing so, apply pressure on the suction nozzle for optimum suction of unclean water. Repeat
several times until the stain is removed.
I
For stubborn stains, you can use the suction nozzle fitted with a brush. First, brush over
the moistened stain to loosen the dirt. Then slowly move the suction nozzle over the stain.
While doing so, apply pressure on the suction nozzle for optimum suction of unclean water.
Repeat several times until the stain is removed.
I
It is normal that not all the moisture will be removed from the surface. The surface will still
be damp. So you should ensure that the cleaned surface is allowed to dry completely to
avoid the formation of mould.
5. Stop using the device immediately when the liquid level (including any foam) threatens to
exceed the MAX indication on the dirty water tank. Remove the dirty water tank. Take off the lid
and carefully empty the tank. Rinse the dirty water tank with clean water and place it back into
the device before resuming cleaning.
6. After use, switch off the device and unplug it. Then clean the device according to the
instructions in the "Cleaning and maintenance" section.
TIP
For stubborn stains, you can use a detergent first:
1. Rub some detergent on the stain with a brush or sponge and allow it to soak in for a while.
2. Afterwards, moisten the stain with the spray function and then vacuum up the water and
detergent. Do not leave behind any traces of detergent on the surface.
36
4
www.domo-elektro.be
6
a
b