Beamz 150.487 Gebrauchsanleitung Seite 3

Display:
This product has an internal control system and interface. The system is configured and navigated via the menu, down and up
buttons shown in the picture below.
When first switch on the unit will automatically enter DMX mode and display (A001) and Obey3 control function. unit has a
memory, so when switched on again the unit will enter the mode you finished with previously.
Press MENU buttons to enter different working modes, the modes are as follows:
Menu button
Mode
DMX512
mode
Auto
mode
Manual mode
Obey3 channel mode
Sound mode
Auto mode: Has 12 patterns in this mode, AP01-AP12 and you can set the speed for each pattern chase.
Manual mode: For colour mixing you can set the intensity of the Red, Blue and Green. You can also set the strobe speed
manually.
Sound mode: You can select the 4 sound modes, SP03 means RGB On/Off, SP02 means color mixing changing, SP01 means
RGB changing, and SP00 means 7-single color changing.
Display
A***
AP**
(12 patterns to select)
(8 patterns to select)
(8 kinds of Red intensity to select)
(8 kinds of Green intensity to select)
coLo
(8 kinds of Blue intensity to select)
(8 strobe speeds to select)
Ob-3
Soun
(4 sound patterns to choose from)
MENU DOWN UP
Down button
A512-A001
(DMX address)
AP12-AP01
F-00 – F-08
No function
r-00 - r-08
g-00 - g-08
b-00 – b-08
F-00 – F-08
3 channel DMX
No function
SP00-SP03
3
Menu button
return back
(DMX address)
return back Enter interface to choose
return back Save data and run
Enter interface to choose
return back
return back Enter interface to choose
return back Enter interface to choose
return back Enter interface to choose
return back Save data and run
return back
Ch1 – Red
Ch2 – Green
Ch3 – Blue
Enter interface to choose
Sound patterns
return back
return back Save data and run
Up button
A001-A512
F00/08
speed
Red
Green
Blue
speed
No function