HP e-modem Installationshandbuch Seite 8

In the event this equipment should fail to operate properly, disconnect the unit from the tele-
phone line. Try using another FCC approved telephone in the same telephone jack. If the trouble
persists, call the telephone company repair service bureau. If the trouble does not persist and
appear s to be with this unit, disconnect the unit from the telephone line and discontinue use of
the unit until it is repaired. Please note that the telephone company may ask that you disconnect
the equipment from the telephone network until the problem has been corrected or until you are
sure that the equipment is not malfunctioning.
The user must use the accessories and cables supplied by the manufacturer to get optimum per-
formance from the product.
No repairs may be done by the customer.
If trouble is experienced with this equipment, please contact your authorized support provider
for repair and warranty information. If the trouble is causing harm to the telephone network, the
telephone company may request you remove the equipment from the network until the problem
is resolved.
This equipment cannot be used on telephone company provided coin service. Connection to
Party Line Service is subject to state tariffs.
When programming and/or making test calls to emergency numbers:

Remain on the line and briefly explain to the dispatcher the reason for the call.

Perform such activities in the off-peak hours such as early morning or late evenings.
The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a com-
puter or other electronic device to send any message via a telephone facsimile machine unless
such message clearly contains, in a margin at the top or bottom of each transmitted page or on
the first page of the transmission, the date and time it is sent and an identification of the busi-
ness, other entity, or individual sending the message and the telephone number of the sending
machine of such business, other entity, or individual.
In order to program this information into your facsimile, refer to your communications software
user manual.
Industry Canada Information
The Industry of Canada label identifies certified equipment. This certification means that the
equipment meets certain telecommunications network prospective, operational and safety
requirements. The department does not guarantee the equipment will operate to the user's
satisfaction.
Before installing this equipment, make sure you are permitted to connect it to the facilities of the
local Telecommunications Company. You must install the equipment using an acceptable method
of connection. In some cases you may also extend the company's inside wiring for single line
individual service by means of certified connector assembly (telephone extension cord). You
should be aware, however, that compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility
designed by the supplier. Any repairs or alterations made by a user to this equipment or
equipment malfunctions, may give the telephone communications company cause to request the
user to disconnect the equipment.
For your own protection, make sure that the electrical ground connections of the power utility,
telephone lines and internal metallic water pipes systems, if present, are connected together.
This precaution may be particularly important in rural areas.
C C C C a a a a u u u u t t t t i i i i o o o o n n n n : : : : Do not attempt to make electrical ground connections yourself, contact the appropriate
electric inspection authority or an electrician.
The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication
of the maximum number of terminals allowed to be connected to a telephone interface. The
termination on an interface may consist of any combination of devices subject only to the
requirement that the sum of the Ringer Equivalence Numbers of all devices does not exceed 5.
PAN European Regulatory Note
The equipment has been approved under RTTE-Directive. For such product, the following state-
ment is required:
"This equipment has been designed to work with main European countries. Network compatibil-
ity is dependent on internal software settings. Contact your vendor if it is necessary to use the
equipment on a different telephone network or for further product support contact your support
provider on the phone numbers provided in the support warranty documentation provided with
the PC.
4 Deutsch