Cleaning; Resetting Factory Settings - Moehlenhoff Display S Anleitung

Alpha IP WTH 61001
27

Resetting factory settings

9 Cleaning

Clean the device with a soft, clean, dry, and lint-free cloth. The cloth may
be moistened with lukewarm water for the removal of heavier contam-
ination. Use a solvent-free cleaning agent for cleaning.
10 Resetting factory settings
All settings will be lost when the factory settings are restored.
1. Pull the device from the frame and the mounting plate (see „Chang-
ing batteries" on page 26).
2. Remove the batteries.
3. Re-insert the batteries according to the marking into the battery
compartments. Simultaneously, press and hold the System key (see
„Device overview" on page 19) for 4 seconds until the LED flashes
rapidly in orange. The display shows "rES".
4. Release the System key.
5. Press the System key again for 4 seconds until the LED lights up in
green.
6. Release the System key again.
9 The device restarts.
9 The factory settings are reset.
DEU ENG FRA
FIN SWE POL
NDL ITA ESP
RUS
DAN/NOR