Garden Equipment Cliplift Magnum Gebrauchsanweisung Seite 3

Setting up
Cliplift Magnum must be used on flat, stable ground without an incline. The perimeter of
use must be secured. Keep children and animals away.
The Cliplift Magnum can be used by one person alone.
1-Insert the pedal in the hydraulic jack, place the access ramps depending on the wheel spacing of the
equipment to be lifted. Lift the support arch to vertical.
Check that the lowering screw is closed (do not over-tighten).
2 - Back the mower onto the wheel supports, placing the rear wheel as close as possible to the support arch.
Pull the handbrake and switch off ignition
3-Turn inwards the front wheel that will remain in contact with the ground before lifting.
EN