Cooling And Mounting; Bec / Running Without Bec - Kontronik KOSMIK 160+ HV Bedienungsanleitung

Number of tones refers to number of con-
nected LiPo cells.
Long signal tone: 4 cells detected
Short signal tone: 1 cell detected
Example:
1 long + 1 short tone:
2 long + 2 short tones:
! The KOSMIK can only recognize the cor-
rect number of connected cells if they are
fully charged !
•Datalogger:
for storage of the operating parameters
•Very sensitive control characteristic:
smooth start-up.
• Sensing and computing of the actual motor
data:
- self adjusting clock frequency
(32 kHz or higher)
- dynamic timing
•Start protection at power up, blocked
motor protection, over temperature pro-
tection, over current limitation.
•Digital microprocessor control,:
therefore no thermal drift.
•Updatable:
online firmware update possible.
•Please note, that the KOSMIK ESC is not
PROGC RD compatible.
•24 months warranty:
for items with EU proof of purchase.
• CE tested
• Fast repair service:
inhouse service center.
• Free of charge Hotline (when calling from
Germany): during our daily business hours.
For informations to business hours see:
www.kontronik.com (Service-Center)
• Developed and produced in Rottenburg,
Germany.

4.2 Cooling and mounting

Sufficient cooling increases efficiency and
lifespan of the ESC.
The KOSMIK ESC improves performance with
increased cooling.
When mounting the ESC to the model, leave
the cooling plate uncovered. If using heat-
sink it should show outwards and never
have connection to other parts of the model.
5 cells
10 cells
When installing the heatsink take care for
good contact with the ESCs cooling plate. For
best transfer between the cooling compo-
nents KONTRONIK advises to fix the heatsink
with a liquid superglue.
4.3 BEC
The KOSMIK ESC has a clocked BEC.
Compared to general BEC-systems the capa-
city of the BEC is mostly independent from
the input voltage. This allows the usage of the
BEC also at higher voltages. Also, the KOS-
MIK features a high interference rejection.
BEC capacity of KOSMIK 160+HV
7A permanent current
20A temporary maximum current
BEC capacity of KOSMIK 200+HV
10A permanent current
30A temporary maximum current
Voltage
The BEC-voltage can be changed between 5V
and 8V (in 0.1V steps) by using the PROG-
DISC.
! For safety reasons, must be either a
2-cell LiFePo battery
(adjusted BEC voltage: 6,6V–7V)
or a 2-cell LiPo battery
(adjusted BEC voltage: 8V)
or a 4-cell NiCd kku
(adjusted BEC voltage: 5,6V)
connected in parallel to the receiver.
TTENTION: please insure previously the
details of the battery, the servos and recei-
ver to be compatible to the requested vol-
tage !
19