Operation; Remote Control; Switching On; Station Tuning - Omnitronic FM TUNER Bedienungsanleitung

6. OPERATION

The TUNA-ONE can either be operated via the buttons on the front panel or via the remote control.
However, the buttons for standby mode and mute can only be found on the remote control.

6.1 Remote control

1
When actuating a button, always direct the remote control towards the sensor. The must be no
obstacles between remote control and the sensor.
2
If the range of the remote control decreases, the batteries are probably exhausted and must be
replaced.

6.2 Switching on

Switch on the unit with the power button. The display shows the station number last selected and the
corresponding receiving frequency. If a program is transmitted in stereo, the indication STEREO appears in
the display.

6.3 Station tuning

To store stations, 20 storage locations are available in the FM range and 20 further storage locations in the
AM range.
1
Switch to FM reception (indication FM) or AM reception (indication AM) with the button AM/FM.
2
Long actuation of the button TUNING [+] (forwards) or TUNING [-] (reverse) starts automatic station
finding. The station finding stops as soon as a station is found. Start the station finding so many times
until the desired station will be received.
3
For manual fine tuning, shortly press the button TUNING [+] or [-] to increase or reduce the received
frequency step by step.

6.4 Storing stations

1
Press the button MEMORY. The station number flashes in the display which signalizes the storage
mode.
2
Select the storage location (the station number) for the station tuned:
• either in steps with the buttons SKIP +/- or
• directly with the station buttons 1 to +10. For direct selection of place 10 shortly press button +10
once, for place 20 shortly press button +10 twice. For places 11 to 19 shortly press button +10 and then
the corresponding station button.
3
Stop the storage procedure with the button MEMORY.

6.5 Automatic station memory

Stations with good reception can also be stored with the automatic station memory. Pressing the button
AUTO SCAN starts the automatic station memory. The automatic station memory will be running forward
and store six stations in the memory. Stations will only be stored in the selected band.

6.6 Calling stored stations

1
To call a stored station, select the corresponding band with the button AM/FM and press the station
button of the station. For direct selection of place 10 shortly press button +10 once, for place 20 shortly
press button +10 twice. For places 11 to 19 shortly press button +10 and then the corresponding station
button.
2
Stations can also be called with the buttons SKIP +/-. SKIP [-] selects the previous station number and
the button SKIP [+] selects the next station number.
3
For muting the sound, press the button MUTE (indication MUTE). To switch on the sound again, press
the button MUTE once again.
18/19 00071452.DOC, Version 1.0