Operating Elements And Connections - Omnitronic FM TUNER Bedienungsanleitung

4. OPERATING ELEMENTS AND CONNECTIONS

1 Power on/off
For switching on and off.
2 Buttons SKIP +/-
For stepwise selection of the stored stations.
3
Standby indicator
4 Infrared sensor for the remote control
5 Display
6 Station buttons 1-9, +10
For direct selection of the stored stations.
7 Button AUTO SCAN
Starts the auto station memory.
12
Antenna connection
Connection for an AM or FM antenna. A basic FM
wire aerial antenna is supplied with the unit.
13
Line output
Stereo output (unbalanced RCA) for connecting an
amplifier, a mixer or other units with line level
inputs.
8 Button MEMORY
To store stations.
9 Buttons TUNING SCAN +/-
For station tuning
• long actuation: starts automatic station finding in
forward or backward direction
• short actuation:
increased or reduced step by step
10
Button FM.ST
Switches the stereo function on and off.
11 Button AM/FM
Switches between FM reception (indication FM and
AM reception (indication AM).
14 Voltage selector switch 115/230 V
15 Fuse holder
Only replace the fuse when the device is
disconnected from mains. Only use fuses of the
same rating and power. The correct value is
specified on the rear panel.
16 Power input
Plug in the supplied power cable here.
15/19
the received frequency
00071452.DOC, Version 1.0
is