Power Supply And Cabling - Janitza electronics JPC 35 Handbuch

Power supply and cabling

The JPC35 must use the 24V DC network connection. The power consumption is 4W.
Warning: Turn off the power supply before connecting the communication cable with the operating
terminal.
Cabling for the power supply off:
1. Pull off the plug and unscrew the screws.
2. Remove the insulation on a length of approximately 7-8 mm.
Guide the cable into the terminal and tighten the screws securely.
3. Put the plug on the operating terminal.
-
FG
DC 24V
Only use copper lines, 60/75°C
Type Wire diameter
(AWG)
Fixed 28-12
Cabled 30-12
c
C
Stripped
length
7-8mm
7-8mm
Attention!
Turn off the power supply before connec-
ting the communication cable with the
operating terminal.
Note:
In the delivery condition, the plug is
plugged into the power supply connection
of the operating terminal.
JPC 35 MultiTouch
Torque
0.5Nm
0.5Nm
67