Only station selection + energy table mode:
Set the number of connected slave devices (see fig. number of slave devices).
Only station selection + energy table mode:
Check the communication status and the incoming serial numbers in the overview window (see
fig. Overview of communication and the serial numbers). The updating can take several seconds!
Set the touchscreen settings if required and check/set the time. (see fig. touchscreen and time
settings).
Assign the measurement points a name. The letter selection occurs via the Alt-key of the display
keyboard (see fig. Assignment of names).
Fig.: Number of slave devices
Fig.: Overview of
communication and the
Fig.:
Touchscreen and time
settings
Fig.: Assignment of names of
the measurement points
serial numbers
JPC 35 MultiTouch
61