Raikko PUMP BLUETOOTH Vacuum Speaker Bedienungsanleitung Seite 8

English
open
To open the PUMP BT Vacuum Speaker and produce the full
®
volume, slide the lock (4) on the back of the speaker to the left. As
you do so, hold the two halves of the speaker together to prevent
them for springing apart suddenly and to relieve pressure on the
locking mechanism.
To close, push the speaker together until the lock engages.
swItCHInG on
Press and hold the on/off switch (2) for 2–3 seconds. A beep will
sound.
Press and hold the switch again to turn the speaker off. A beep will
sound once again.
Pressing the on/off button (2) briefly switches between Bluetooth
and cable mode.
When Bluetooth is in operation, the LED indicator will flash at
®
short intervals. In cable mode, the indicator will be illuminated
continuously.
When it has been switched on, the speaker will be in 'pairing mode'.
It looks for devices with an activated Bluetooth
can now be connected to the PUMP BT
information on this topic, please read the operating instructions for
your device.
14
PUMP BLUETOOTH ® Vacuum Speaker
interface. These
®
Vacuum Speaker . For more
®
English
If there is already a Bluetooth
the speaker has previously been connected, this connection takes
priority and is made without being requested. The simultaneous
linking of several devices is not possible. Only one playback device
has access to the speaker at any given time.
voLUMe
Set the volume using the volume control on your playback device.
It is also possible to adjust the volume on the speaker. Increase
the volume by sliding the spring slider (1) to the right. Reduce the
volume by sliding it to the left. The slider can be held to adjust the
volume. A short press switches to the next or previous track in
Bluetooth mode.
®
Caution! It is very possible to overload the speaker with an
excessive signal level. Select a volume level where there
is no distortion.
®
High sound levels can damage your hearing. Do not hold
the speaker directly against your ear, other people's ears
or animals' ears.
opeRAtIon vIA BLUetootH
Provided that the device used supports the required Bluetooth
standards (A2DP1.2, AVRCP1.0, Headset profiles 1.1/Hands-Free
Profiles 1.5), then you can use the PUMP BT
operate this from any location.
Press button (1) once to start or stop playing back songs.
PUMP BLUETOOTH ® Vacuum Speaker
-enabled device nearby with which
®
®
Vacuum Speaker to
®
®
15