Exsys EX-60222 Anleitung

HARDWARE INSTALLATION
Please note the following installation instructions. As there are major differences between PCs, we
can only provide you with general instructions for installing the EX-60222. If in doubt, please consult
the manual for your computer system.
1. Switch off your computer and all connected peripheral devices and unplug all devices from the
mains.
2. Loosen the housing screws on the back of your computer and carefully pull off the housing.
3. Now locate a free PCI Express slot (x4 or larger) and carefully insert the card into the selected
PCI Express slot. Make sure that the card is seated correctly and that there is no short circuit.
4. Then secure the card to the housing with a screw.
5. Now close the computer housing with the previously removed screws.
DRIVER INSTALLATION
Windows / Linux
Once the hardware installation is complete, the operating system automatically recognizes the
card and installs it!
CHECK INSTALLED DRIVER
Open the >Device manager<. Now you should see at „Network adapters" the following new
entries:
If you see these or a similar informations the device is installed correctly.
5
Germany: Switzerland: Italy:
EXSYS Vertriebs GmbH EXSYS Vertriebs GmbH EXSYS Italia Srl
Industriestrasse 8 Dübendorfstrasse 17 Via Belvedere, 45/B
61449 Steinbach 8602 Wangen I-22100 Como
www.exsys.ch www.exsys.it
www.exsys.de
6
Anleitung
Vers. 1.1 / 16.03.26
AUFBAU
Status LEDs pro Anschluss
2x RJ45 Anschluss
BESCHREIBUNG & TECHNISCHE DATEN
Die EX-60222 ist eine schnelle 10 Gigabit Ethernet Karte mit zwei RJ45 Anschlüsse, entwickelt
für den PCIe (x4) Bus. Die EX-60222 unterstützt eine Datenübertragungsrate von bis zu 10000
Mbit pro Sekunde. Sie unterstützt Half- und Full-Duplex sowie Auto-Negotiation zur
automatischen Anpassung an die Geschwindigkeit im Netzwerk (10/100/1000/2500/5000/10000
Mbit/s). Der verwendete Intel Chipsatz garantiert höchste Qualität und Zuverlässigkeit.
Kompatibilität: PCI-Express x4 bis x16
Betriebssysteme: Windows 7 / 8.x / 10 / 11 / Server 20xx / Linux
Anschlüsse: 2x 10 Gigabit Ethernet RJ45 Anschluss
Lieferumfang: EX-60222, Low Profile Bügel, Anleitung
ANSCHLÜSSE & LEDS
RJ45 Anschluss:
RJ45 Anschluss
Pin Signal Pin Signal
1 BI_DA+ 4 BI_DC+
2 BI_DA- 5 BI_DC-
87654321
3 BI_DB+ 6 BI_DB-
Status LEDs:
LED Name Farbe
Gelb:
Gelb
Speed Grün:
Grün
Aus:
Steady on: Verbunden
LINK (ACT) Grün Blinking:
Aus:
1
EX-60222
Pin Signal
7 BI_DD+
8 BI_DD-
LED Funktion
10 Gbps
1000 Mbps
10/100 Mbps
Datenübertragung
Keine Verbindung