Indicator Lights - Bauknecht GMI 50102 IN Kurzanleitung

QUICK REFERENCE GUIDE
Before using the dishwasher, you are advised to read the user instructions!
On/Off button
Press the button to switch on the
dishwasher. The indicator light for the last
programme to be selected lights up; at the
end of the cycle the dishwasher emits a
brief audible signal.
Programme selection button
Press this button to select the desired
programme.
The indicator light of the selected
programme illuminates.
Start button
Press to start the wash cycle and keep
pressed until an acoustic signal confirms
the start of the cycle and the indicator
lamp of the selected programme flashes.

Indicator lights

Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Add rinse aid
Options
Half load
selector button
Press this button to select the half load
option; the corresponding indicator light
will illuminate. Press the button again to
the deselect the option; the corresponding
indicator light will go out.
The half load function is suitable for
smaller wash loads. The dishes should be
distributed over both racks.
"Delayed start" button
The wash cycle can be programmed to
start after 3-6-9 hours. Press button to
select the delayed start.
The corresponding indicator lamp lights up.
After a pre-wash of the dishes the previously
set wash is started. To quit selection and start
the wash program without the delayed start,
press button until the 3-6-9 indicator lamps
go off.
Programming and option selection are only
possible with the
D GB
door closed .
GB