Herunterladen Inhalt Inhalt Diese Seite drucken

Indicator Lights - Bauknecht GMI 61102 IN Kurzanleitung

Vorschau ausblenden Andere Handbücher für GMI 61102 IN:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

QUICK REFERENCE GUIDE
Before using the dishwasher, you are advised to read the user instructions!

Indicator lights

Programming and option selection are only possible with the
Downloaded from
www.Manualslib.com
On/Off button
Press the button to switch on the
dishwasher. The indicator light for the last
programme to be selected lights up; at the
end of the cycle the dishwasher emits a
brief audible signal.
Programme selection button
Press this button to select the desired
programme.
The indicator light of the selected
programme illuminates.
Start button
Press to start the wash cycle and keep
pressed until an acoustic signal confirms
the start of the cycle and the indicator
lamp of the selected programme flashes.
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Add rinse aid
Display
The display shows all informaion
concerning programmed functions and
indicates if a fault has occurred (see
table).
manuals search engine
Options
Half load
selector button
Press this button to select the half load
option; the corresponding indicator light
will illuminate. Press the button again to
the deselect the option; the corresponding
indicator light will go out.
The half load function is suitable for
smaller wash loads. The dishes should be
distributed over both racks.
Antibacterial rinse
(Sani Rinse option)
This function adds an antibacterial rinse at
the end of the wash cycle, guaranteeing a
further reduction of bacteria. The indicator
light illuminates when the function is
activated.
If the temperature is not maintained at a
constant level during the antibacterial rinse
programme (e.g. if the door is opened or
there is a power cut), the programme
indicator lights will flash to signal that the
sanitizing effect of the antibacterial rinse is
not guaranteed.
«Delayed start» button
The wash cyle can be programmed to start
after 1-24 hours. Then press the Start
button. After a prewash the set delay will
start.
door closed
D
GB
GB
.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis