Cleaning, Maintenance And Ordering Of Spare Parts - Einhell Tp-Apd 18/321 Li Bl Originalbetriebsanleitung

6. Operation
6.1 On/Off switch (Fig. 1/Item 1)
To switch on:
Press the locking button (2) and the On/Off switch
(1).
Infi nitely variable stroke speed control is possible
with the On/Off switch (1). The further you push
the switch, the higher the stroke speed.
To switch off :
Release the locking button (2) and the ON/OFF
switch (1) at the same time
6.2 Use as a jigsaw (Fig. 6)
Place the multi-saw on the material to be cut as
shown in Fig. 6. Switch on the multi-saw and push
it along against the material to be cut. Adapt your
cutting speed to the material.
6.3 Preselecting the speed (Fig. 7/Item 7)
The speed controller (7) enables you to defi ne
the maximum speed.
•
Set the speed controller (7) to the required
position.
•
With the On/Off switch (1) pressed right in,
the motor will now run as quickly as was set at
the speed controller (7).
•
The setting can also be made during opera-
tion.
6.4 Setting the pendulum action (Fig. 7/Item
8)
The pendulum action for the saw blade can be
switched on or off at the selector switch for pen-
dulum action (8).
Set the selector switch for pendulum action (8) to
one of the following positions:
Position A = pendulum action off
Material: Rubber, ceramic, aluminium, steel
Please note: For fi ne clean cuts, thin materials
(e.g. sheet steel) and hard materials.
Position B = pendulum action on
Material: Wood
Please note: For soft materials and sawing along
the grain
The best combination of speed and pendulum ac-
tion depends on the material you want to saw.
We recommend you to make a trial cut on a waste
Anl_TP_APD_18_321_Li_BL_SPK13.indb 16 Anl_TP_APD_18_321_Li_BL_SPK13.indb 16
EN
piece in order to check the ideal settings.
6.5 Fastening hook (Fig. 8/Item 9)
The cordless universal saw can be attached to
stair railings, scaff olding, etc. using the fastening
hook.
To do this, unfold the fastening hook as shown in
Fig. 8 and hang the device at the desired location.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always remove the battery pack before making
adjustments to the equipment.
7.1 Cleaning
•
Keep all safety devices, air vents and the mo-
tor housing free of dirt and dust as far as pos-
sible. Wipe the equipment with a clean cloth
or blow it with compressed air at low pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the
plastic parts of the equipment. Ensure that no
water can seep into the device. The ingress of
water into an electric tool increases the risk of
an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
9.3 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.Einhell-Service.com
Tip! For good results we
recommend high-quality ac-
cessories from
www.kwb.eu
welcome@kwb.eu
- 16 -
!
23.06.2025 09:20:10 23.06.2025 09:20:10