Electrical Interconnection - Renegade Rxv1000A Betriebsanleitung

ELECTRICAL INTERCONNECTION

1
BEFORE THE INTERCONNECTION
For the professional installation of a sound system appropriate wiring kits are available in car audio retailer stores. Ensure a
sufficient profile section (at least 10 mm
wiring kit. Clean and remove rust-streaked and oxidized areas on the contact points of the battery and the ground connection.
Make sure that all screws are fixed tight after the installation, because loosely connections may cause malfunctions, insufficient
power supply or interferences. We recommend therefore the RENEGADE REN10KIT wire kit.
1
FUSE
The inserted fuse protects the device against short circuits and overload. The standard fuse rating of 15 A must be
strictly adhered, when you replace a defective fuse.
2
BATT+
Connect the BATT+12V-terminal with the +12V pole of the vehicle's battery. Use a suitable cable with a sufficient cross
section (at least 10 mm
the battery should be shorter than 30 cm. Do not set in the fuse into the fuse block until the installation is accomplished.
3
REM (TURN-ON SIGNAL)
Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote wire of your head unit with the REM-terminal
of the sound system. Use a suitable cable with a sufficient cross section (0,5 mm
on or off automatically with your head unit. If your head unit is not equipped with a remote wire, refer to page 10, section
#6. If you use the HIGH LEVEL INPUT like described there, you must not connect the turn-on signal under REM.
4
GND
Connect this GROUND terminal with a suitable contact ground point on the vehicle's chassis. The ground wire must be
as short as possible and must be connected to a blank metallic point at the vehicle's chassis. Ensure that this ground
point has a stable and safe electric connection to the negative "–"pole of the battery. Check this ground wire from the
battery to the ground point if possible and enforce it, if required. Use a ground wire with a sufficient cross section (at least
10 mm 2 ) and the same size like the plus (+12V) power supply wire.
NOTE
Before you start with the installation of the sound system, disconnect necessarily the GROUND connection wire
from the battery to avoid any risk of electric shocks and short circuits.
2 3 4
), a suitable fuse rating and a high conductivity of the cables when you purchase your
2
) and install an additional in-line fuse. For safety reasons the distance between the fuse block and
2
). Thereby the sound system will turn
2
9
ENG