Mounting To The Digital Camera - Panasonic LUMIX DMW-YAGHE Bedienungsanleitung

ENGLISH

Mounting to the Digital Camera

yMake sure that a DC power supply is not connected to the unit's DC IN terminal and that the
y
digital camera is turned off.
(Mounting or dismounting while the power is on may result in malfunction.)
1
Remove the cover for the battery grip connector and cover for the interface unit
connector on the digital camera, and  remove the electrical contact and interface
contact caps on the unit.
yStore the connector covers and contact caps safely to avoid loss.
y
yTo protect the terminals, reattach the covers and caps after you finish using the unit.
y
Cover for the battery grip
connector
2
Loosen the HDMI connection terminal screw (A),
and slide the HDMI connection terminal out to the
side.
yDo not twist or pull the HDMI connection terminal with
y
excessive force. Doing so may result in malfunction
or damage.
3
Align the attachment screw, contacts, and camera
attachment pins, and attach the digital camera.
4
Rotate the attachment screw (B) in the direction of
the arrow and tighten it securely.
yVerify that the attachment screw is tightened securely
y
during use.
5
Open the terminal cover on the digital camera, slide
the HDMI connection terminal on the unit inward
(toward the camera) to connect it, and tighten the
HDMI connection terminal screw (A) securely.
yOpen the terminal cover on the digital camera 90
y
degrees, and store it in the HDMI connection terminal.
„ Dismounting from the digital camera
„
yMake sure that a DC power supply is not connected to the unit's DC IN terminal and that
y
the digital camera is turned off, and then perform the mounting procedure in reverse order
(disconnect the HDMI connection terminal before rotating the attachment screw (B)).
Performing the procedure in the incorrect order may result in damage.
8
VQT5K49 (ENG)

Cover for the interface unit
connector
Terminal caps

Terminal cover
90°
(A)
(B)