Turning On The Led Light; Wireless Flash Settings - Panasonic DMWFL200LE Bedienungsanleitung

Turning on the LED Light

Rotate the LED light output
control dial.
Rotating in the direction of 1:
Decreases the amount of light or turns
off the LED light.
≥ When you rotate the dial until it stops, the LED light turns
off.
Rotating in the direction of 2:
Increases the amount of light.
≥ The flash and batteries may become warm if you keep the
LED light on, but this is not a malfunction.

Wireless Flash Settings

Wireless control is available with Panasonic digital cameras
that support wireless mode. See the operating instructions
of the digital camera for operation of the digital camera
during wireless flash shooting.
1 Set the camera to wireless
mode.
2 Set the flash to [RC] mode.
"Flash Mode" (P9)
3 Rotate the flash head.
10
SQT1378
4 Set the channel with the
[CH] switch.
• Set the camera and flash to the
 
same channel.
5 Set the group with the [GR]
switch.
• The camera can adjust flash
settings separately for up to 3
groups; choose the group to which
the flash belongs.
≥ If it is difficult to slide the switch, use the tip of a ball point
pen or similar tool to slide it.
≥ After setting the channel and group, return the flash head
to its original angle.
The Firing mode, the flash adjustment, and the manual
flash adjustment can be set for each group by operating the
camera.
≥ The flash will operate as follows when you set the camera
to a setting not supported by the flash:
Camera
[Firing Mode]: [AUTO]
[Wireless FP]: [ON]
Flash
Does not fire.
Fires as normal.