Exsys EX-13022 Anleitung

CONNECTORS & STATUS LEDs
USB 2.0 A-Plug:
USB 2.0 A-Plug
Pin Signal Pin
1 VCC 3
2 DATA- 4
HARDWARE INSTALLATION
Because there are large differences between PCs, we can give you only a general installation guide
for the EX-13022. Please refer your computers reference manual whenever in doubt.
1. Connect the EX-13022 USB to the USB A-Port at the your PC.
2. When you are ready you can start your PC and continue with the point „Driver Installation".
DRIVER INSTALLATION
Windows
After the hardware installation Windows will recognize the device automatically and install the
drivers. If the driver shoul not be installed automatically, please download the driver from our
homepage (www.exsys.de / www.exsys.ch) first. Now select the folder with your operating
system and install the driver. Follow the hardware assistant and finish the installation.
Important! Restart your PC in any case after installing the drivers.
CHECK INSTALLED DRIVER
Open the >Device manager<. Now you should see at „Ports (COM & LPT)" and „USB-
Controller" the following new entry:
If you see this or a similar information the device is installed correctly.
5
HARDWARE INSTALLATION
For cleaning please use only a dry fluff less cloth and remove the dirt with gently pressure. In
the area of the connectors please make sure that no fibres from the cloth remain in the connect-
ors. Never use a moist or wet cloth for cleaning!
Signal
DATA+
GND
Germany: Switzerland:
EXSYS Vertriebs GmbH EXSYS Vertriebs GmbH
Industriestrasse 8 Dübendorfstrasse 17
61449 Steinbach 8602 Wangen
www.exsys.ch
www.exsys.de
Italy:
EXSYS Italia Srl
Via Belvedere, 45/B
I-22100 Como
www.exsys.it
6
Anleitung Anleitung
Vers. 1.0, 21.02.26
AUFBAU
2x 9 Pin Stecker Seriell RS-232
BESCHREIBUNG & TECHNISCHE DATEN
Das USB zu RS-232 Kabel mit USB-A Stecker stellt zwei serielle RS-232 High Performance
UART 16C550 Ausgänge zur Verfügung. Es wurde entwickelt, zwei weitere serielle Ausgänge
für Notebook, PC, Workstation oder Server über den USB 1.1, 2.0 oder 3.2 Bus zu erweitern.
Dank der einfachen Installation am USB-Port muss der Rechner nicht geöffnet werden und das
Konverter-Kabel EX-13022 kann bei laufendem Betrieb installiert werden.
Kompatibilität: USB 1.1, 2.0 & 3.2
Betriebssysteme: Windows 9.x / ME / 2000 / XP / Vista / 7 / 8.x / 10 / 11 / Server 20xx/
Linux / MAC
Anschlüsse: 1x USB 2.0 A-Stecker, 2x 9 Pin Stecker Seriell RS-232
Lieferumfang: EX-13022
1
EX-13022
USB 2.0 A-Stecker
zum Anschluss an PC