Mounting The Finit-Easy; Mounting The Protective Cover - CIBO Finit-easy Leitfaden

Manuel Finit-Easy

Mounting the Finit-Easy

Mounting the protective cover

Mounting
• Push the button on the back of the arm and keep it pushed in.
Slide with the other hand the protective cover from bottom to top into the slot.
•
First slide the guide with the biggest diameter about 5mm in the outer slot. Next follows the
guide with the smallest diameter, which slides into the inner slot.
ATTENTION: Never attempt to slide both guides at the same time in the slots,
this will not work. Always start with the outer slide, the inner slide will follow automatically.
• Put the protective cover in the desired position.
• Unleash the button to secure the position.
Relocating the protective cover
• Push the button on the back of the arm and keep it pushed in.
• Shift the protective cover until it reaches the desired position.
• Unleash the button again.
UK
27