Exodraft RSHG Bedienungsanleitung Seite 5

3000126-RSHG-UK-DE
Before fitting onto a steel chimney
Step
1 A flange (C) is used, fitted so that the spigot end sits
inside the chimney (D).
2 Place the mineral wool mat (A) on the flange (C) with
aluminium foil facing upwards and cut a hole in the
mineral wool mat, the hole being the same diameter as
the flange hole.
3 Cut the corners of the mineral wool mat, so there is room
to fit the vibration dampers (B).
If a temperature sensor is to be installed with the
chimney fan, cut the aluminium foil on the mineral wool
mat to make room for the sensor; this also ensures that
the mat sits level on the chimney.
4 Fit the flange to the chimney fan, with the use of
vibration dampers supplied with the flange.
5 The fan can now be fitted onto the chimney.
Fitting the chimney fan onto the chimney
Step
1 The chimney fan is now ready for mounting. Place the
glass fibre mat on top of the chimney, the aluminium foil
facing upwards, and place the chimney fan on top of the
mat.
Action
Action
A
B
C
D
UK •
5