Installation Instructions - Exodraft Rshg Bedienungsanleitung

• UK
4
1.2

Installation instructions

Before fitting onto a chimney
the fan is to be mounted onto a brick chimney
the fan is to be mounted onto a steel chimney
it is an RSHG014
remove the transport safety bolt on the hinges
before mounting.
Before fitting onto the brickwork of a chimney
Step
1 Measure the inside diameter of the chimney and
cut the size of the hole in the mineral wool mat
accordingly.
Note that there must always be a minimum of
20 mm of mat surface at any point around the
circumference of the hole.
NB: The side of the mineral wool mat covered in
aluminium foil is to be placed uppermost, i.e. facing
the fan.
2 Mount and fasten the location brackets in the
underside of the base plate by means of the bolts
and nuts supplied.
Please notice that the bolt is to be inserted from
beneath.
3 Adjust the distance between the location brackets
to fit the inside diameter of the chimney, and then
tighten the nuts. Note that there should be a 2-4
mm gap between the brackets and the chimney so
as to avoid transmitting vibrations from the fan to
the chimney.
A and B measurements – please refer to step 1.
If ...
Action
then ...
the chimney must have location brackets – see below
a flange is required (supplied as an extra ) -see below
3000126-RSHG-UK-DE