Cleaning, Care & Maintenance - Buffalo Ja373 Bedienungsanleitung

EN
Cleaning, Care &
Maintenance
Food residues on the machine should be cleaned
regularly. Improper cleaning may shorten the
service life and lead to product damage.
Do not use abrasives/chemical products or hard
brushes/objects for cleaning, which may cause
damage to the surface and components.
Periodic/thorough cleaning:
1. Turn off and disconnect the appliance from the power supply before cleaning.
2. Set both thickness adjustment knobs to the maximum thickness to facilitate cleaning.
3. Remove the upper and lower guards by loosening the fixing screws. Detach the springs from the
support column then disassemble the scrapers in the direction as arrowed.
4. Remove all food residues from all parts using a cloth dampened with water and neutral food-grade
detergent.
5. Use warm, soapy water and a damp cloth to clean all removable parts. No parts are dishwasher safe.
6. Dry all parts well and re-assemble into position.
7. Leave the appliance idle for about 5 minutes before re-use.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The unit is not working
Appliance stops working
suddenly
Appliance does not run
smoothly
6
JA373_ML_A5_v1_20250828.indb 6 JA373_ML_A5_v1_20250828.indb 6
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Overload protection is
activated
Dough is too big/jammed
Daily cleaning:
Ensure the unit is in a safe and stationary state.
1. Turn off power supply and wipe the rollers
with a damp towel/cloth to clean off any flour
residue on the front.
2. Turn on power supply to let the rollers rotate.
Once the dirty side comes to the front, turn off
again and wipe the rollers while stationary.
Scraper
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the plug fuse
Check mains power supply
1. Turn off and disconnect from power supply
2. Remove dough and allow to cool down for
about 20 seconds
3. Press the over-current protection switch to
reset
1. Turn off and disconnect from power supply
2. Remove jammed dough
Spring
2025/8/28 14:11 2025/8/28 14:11