Nobile R1S Betriebsanweisung Seite 3

Montage-/ Betriebsanleitung
Mounting-/Operation Instruction
EN
Congratulations on your purchase of this nobilé-product!
You have decided on a high-quality product which is manufactured with the utmost care and subject to several quality controls. Safe use of the product is only guaranteed
if each instruction is followed accordingly. In case of damage caused by non-observance of these instructions the warranty expires. The installation and electrical
connection must be done by an authorized expert (e.g. electrician) in compliance with existing standards and local code. Prior to any installation or maintenance work,
mains must be disconnected. Before putting in operation, make sure any component of the entire installation does not bear a risk of life. According to common practice,
please perform a standard function test, before installing. To make maintenance work possible, the lighting system should be accessible after installation (auditable).
Energy efficiency class of the light source:
R1S
R2S
R2S UGR≤19
R3S UGR≤19
Connection Diagram:
A. Connection for non-dimmable
C. Connection for 1-10V dimming
F. Connection to any desired 1050mA constant current LED driver
LED Panel R1S / R2S / R3S 38W
3000K
Technische und gestalterische Änderungen im Zuge stetiger Produktentwicklungen vorbehalten.
Technical and design changes due to product developments are subject to change without prior notice.
nobilé AG – Wächtersbacher Str. 78 - 60386 Frankfurt/M. Germany - www.nobile.de
B. Connection for phase dimming
D. Connection for Dali dimming
*Do not connect the luminaire to an active LED driver.
Some LED drivers emit high voltage when idle, which
may cause permanent damage to the luminaire. Be
sure to disconnect the LED driver from the power line
before connecting the luminaire.
rev. 0.1 – 08.11.2021
Seite 3 von 4
4000K