Maintenance And Cleaning - D+H Vcd 204-Tms+ Set Originalanweisungen

WARNING
Read all safety warnings, instructions, illustrations
and specifications provided with this product.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
Safety notes
Safety extra low voltage 24 V DC!
Do not connect directly to the mains supply!
- Connection has to be carried out only by an
authorized electrical specialist
- Danger of violent pressure in handaccessible area
- Keep away People from the operating area of the
drive
- Keep away children from the control
- Use only in dry rooms
- Only for inside mounting.
Use rain detector with danger of rain
(e.g. at domelights or roof windows)
- Just use unchanged original D+H parts
- Observe mounting instructions of bracket set!
Observe enclosed r ed safety slip!
Extent of supply
Drive unit with 2,5 m PVC cable. Dependent on the
type of window, different bracket sets are available
separately.

Maintenance and cleaning

Maintenance work is only allowed when the device is in
a de-energized condition! Inspection and maintenance
has to be carried out according to D+H maintenance
notes. Only original D+H spare parts may be used.
Repair is to be carried out exclusively by D+H.
Wipe away debris or contamination with a dry, soft
cloth.
Do not use cleaning agents or solvents.
99.831.06 1.4/04/23
Intended use
- Chain drive for electric opening and closing of
windows and flaps in the facade and roof area
- Useable for daily natural ventilation
- Operating voltage 24 V DC
- Only for inside mounting
Performance features
- Micro processor controlled electronics
- Individually programmable via Powerline (PLP1
and SCS)
- Stroke programming with magnet
- Low running noises
- Connection via plug connector
- Symmetrical chain outlet
- Tandem-safety function for operation of two
VCD 204 drives on one sash
TMS+ / -BRV function
Up to two VCD 204 drives and one locking drive can be
used in tandem. Combined TMS+ and BRV signal.
The BRV signal is only output when in the end
position - this prevents locking drives and modules
from malfunctioning.
During the learning phase, the activated stroke is
transferred to the tandem drive via the TMS+
function.
Declaration of Conformity
We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following
2014/30/EU, 2011/65/EU
S.I. 2016/1091, S.I. 2012/3032
Technical file at:
D+H Mechatronic AG, D-22949 Ammersbek
Dirk Dingfelder
CEO
18.04.2023
English
regulations :
Maik Schmees
CTO
VCD 204
5/16