Herunterladen Diese Seite drucken

ROSIERES RT623/1 Installations- Und Gebrauchsanleitung Seite 2

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

ENGLISH
WARNING
The distance between the supporting surface for the cooking vessels on the hob and the lower part of the hood must
be at least 65 cm. If the instructions for installation for the hob specify a greater distance, this has to be taken into
account.
The air collected must not be conveyed into a duct used to blow off smokes from appliances fed with an energy other
than electricity (central heating systems, ther-mosiphons, water-heaters, etc.).
Comply with the official instructions provided by the competent authorities in merit when installing the disposal duct.
In addition, exhaust air should not be discharged into a wall cavity, unless the cavity is designed for that purpose.
The room must be well aerated in case a hood and some other heat equipment fed with an energy other than electricity
(gas, oil, coal heaters, etc) operate at the same time. In fact the intake hood, disposing of air, could create a vacuum
in the room. The vacuum should not exceed 0,04mbar. This prevents the gas exhausted by the heat source from
being intaken again. It is therefore advisable to ensure the room contains air taps able to ensure a steady flow of
fresh air.
Check the data label inside the appliance; if the symbol (
such technical particulars that it belongs to class II insulation, therefore it must not be earthed.
Check the data label inside the appliance; if the symbol (
This appliance must be grounded. When making the electrical connections, check that the current socket has a
ground connection.
When making the electrical connections, check that the voltage values correspond to those indicated on the data
plate inside the appliance itself.
In case your appliance is not furnished with a non separating flexible cable and has no plug, or has not got
any other device ensu-ring omnipolar disconnection from the electricity main, with a contact opening distance
of at least 3 mm, such separating device ensuring disconnection from the main must be included in the fixed
installation. If your unit features a power lead and plug, position this so the plug is accessible.
Always switch off the electricity supply before carrying out any cleaning or servicing operations on the
appliance.
USE
Avoid using materials which could cause spurts of flame (flambées) near the appliance.
When frying, take particular care to prevent oil and grease from catching fire. Already used oil is especially dangerous
in this respect. Do not use uncovered electric grates.
To avoid possible risks of fire always comply with the indicated instructions when cleaning grease filters and when
removing grease deposits from the appliance.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do
not play with the appliance.
Caution: accessible parts may become hot when used with cooking appliances.
This kitchen hood is intended for installation in domestic kitchens above cooktops, cooking devices and similar
kitchen equipment.
MAINTENANCE
Thorough servicing guarantees correct and long-lasting operation.
Particular care must be paid to the grease filters which must be periodically cleaned in relation to use (at least once
every two months). Remove the grease filters and wash them either by hand or in the dishwasher using neutral detergent.
To take off the grease filters: at the handle, push the stop inwards and pull the filter downwards (Fig.4); open the
trolley and take off the other filter doing the same.
Any fat deposits should be removed from the appliance periodically depending on amount of use (at least every 2
months). Avoid using abrasive or corrosive products. To clean painted appliances on the outside, use a cloth dipped
in lukewarm water and neutral detergent. To clean steel, copper or brass appliances on the outside, it is always best
to use specific products, following the instructions on the products themselves. To clean the inside of the appliance,
use a cloth (or brush) dipped in denatured ethyl alcohol.
DESCRIPTION
The appliance can be a filtering version one, a ducting version one or with an external motor.
In the Filtering version (Fig. 1), the air and vapours conveyed by the appliance are depurated by charcoal filter
and recirculated around the room. ATTENTION: Using the hood as a filtering one it is necessary to use the charcoal
filter that purifies the air sent back into the room.
In the Ducting version (Fig. 2), cooking vapours and odours are conveyed straight outside by a disposal duct
) is printed, read the following: this appliance has
) is NOT printed, read the following: ATTENTION:
loading

Diese Anleitung auch für:

Rt923/1