INNOCIGS CUBOID 200W Bedienungsanleitung Seite 46

INNOCIGS CUBOID 200W BATTERY – OPERATING & CHANGING THE MODES
After pressing the fire button three times in quick succession, the first two lines will blink to show that you are in
the menu. Press the right "up" button to switch between VW, BYPASS, TC-Ni, TC-Ti, TC-SS316 and TCR modes.
Press the fire button or wait until the display flashes ten times to confirm the current settings and exit the menu.
Adjusting the TCR Mode
While the Cuboid 200W is turned off, press the fire button and the right simultaneously for 5 seconds to
enter the TCR menu:
1. Press "up" or "down" buttons to switch between TCR M1, M2 and M3.
2. Confirm the desired mode by pressing the fire button.
3. Press the "up" or "down" button to increase or decrease the parameters
4. Confirm your setting by holding the fire button or wait 10 seconds.
44