VEVOR RF-03-02 Bedienungsanleitung Seite 4

INSTALLATION METHOD
1.
Clip the iron hook in the accessory bag onto the wire of the mesh against
the wall.
2.
Mark the position of the installation hole on the wall with a marker pen and
calibrate it with a level.
3. Drill holes with a 1/4 inch drill bit at the center of each marked position.
4.
Use a hammer to drive the anchor bolt into the pre drilled hole.
5. Screw the screw into the wall to secure the iron hook.
6. Secure the support bracket and confirm the hole position.
7. Mark the hole position with a pencil.
8. Drill a hole with a 1/3-inch drill bit at the center of the marked position.
9. Use a hammer to drive the anchor bolt into the pre drilled hole.